WXD Alloy Steel Cardan Cross Universal Joint Pin

Structural Characteristics:

1. It is suitable for transmission applications where the angle of the two axes on the same plane of the connecting space β≤ 45 degrees, and the transmission torque is 11.2 to 1120 N.m.

2. The maximum interaxle angle per joint is 45 degrees.

3. Finished hole tolerance H7, according to the requirements, it could process key slot, hex hole and quad hole.

4. The angle between the two axes was abled to vary within a limited range as required in work.

5. Joint part quenching 43 to 46 degrees, center slider quenching 48 to 52 degrees, pin shaft carburizing quenching 38 to 42 degrees.

6. Two types of bearings: Block bearings (up to 1000RPM). Rolling pin bearings (up to 4000RPM, high transmission accuracy, high dynamic load, small bearing clearance)

Installation Note：

1. When installing a single cross axis universal coupling, the main and driven end angle speeds vary, the main and driven axes can not be kept in sync, and their out-of-syncity varies with the β angle.

2. To achieve the same angular speed and synchronous rotation, a double-cross-axis universal coupling should be installed or used by a combination of two single-cross-axis universal couplings and an intermediate shaft.

Drawings：

Parameter Sheets：