The EK1100 coupler is used to connect EtherCAT to EtherCAT terminal modules (Elxxxx). A station consists of an EK1100 coupler, any number of EtherCAT terminal modules, and a bus end terminal module. This coupler converts the transmission message from Ethernet 100BASE-TX into an E-bus signal.

The coupler is connected to the network through the Ethernet interface above. The RJ45 interface below can be used to connect other EtherCAT devices on the same network segment. In the EtherCAT network, the EK1100 coupler can be installed anywhere in the Ethernet signal transmission section (100BASE-TX), but cannot be directly installed on the switch. The coupler BK9000 (used for K-bus components) can be directly connected to the switch.

BECKHOFF Plc Module

BK1120 BK1250 BK2000 BK2010

BK2020 BK2500 BK3000 BK3010

BK3100 BK3110 BK3120 BK3150

BK3500 BK3520 LC3100 BK4000

BK4010 BK4020 BK4500 BK5000

EK1000 EK1100 EK1101 EK1122

EK1501 EK1521 EK9750 EK1110

KL1002 KL1012 KL1032 KL1052

KL1104 KL1114 KL1124 KL1154

KL1164 KL1184 KL1194 KL1202

KL1212 KL1232 KL1302 KL1304

KL1312 KL1314 KL1352 KL1362

KL1382 KL1402 KL1404 KL1408

KL1412 KL1414 KL1418 KL1434

KL1488 KL1498 KL1501 KL1512

EL1002 EL1004 EL1008 EL1012

EL1014 EL1018 EL1024 EL1034

EL1084 EL1088 EL1094 EL1098

EL1104 EL1114 EL1124 EL1134

EL1144 EL1202 EL1252 EL1262

EL1502 EL1512 EL1702 EL1712

EL1722 EL1904 EL2002 EL2004

EL2008 EL2022 EL2024 EL2032

CX900M-UC0T CX9000-0000

CX9000-0001 CX9001-0000

CX9001-0001 CX9001-0100

CX9001-0101 CX9000-1000

CX9000-1001 CX9001-1000

CX9001-1001 CX9001-1100

CX9001-1101 CX9000-N010

CX9000-N030 CX9000-N031

CX9000-A001 CX9010-UC0T

CX9010-0000 CX9010-0001

KM1002-0000 KM1002-0001

KM1002-0002 KM1002-0004

KM1012-0000 KM1012-0001

KM1012-0002 KM1012-0004

KM1004-0000 KM1004-0001

KM1004-0002 KM1004-0004

KM1014-0000 KM1014-0001

KM1014-0002 KM1014-0004

KM1008-0000 KM1008-0001

KM1008-0002 KM1008-0004